Skytrak 6042 Service Manual User Manual download pdf (Page 114)

Boom

3.68

Model 6042 Legacy Origin 7/02

3.6 QUICK ATTACH ASSEMBLY

This vehicle is equipped with a quick attach system for

easy attachment changes.

3.6.1 Disconnecting from an Attachment

1. Park the vehicle on a hard, level surface.

2. Ground the attachment, place the travel select lever

in the (N) NEUTRAL position, place the neutral lock

lever in the (N) NEUTRAL LOCK position and

engage the parking brake switch.

3. Extend the boom approximately 10 ft (3,05 m) and

tilt the carriage backward. Shut the engine OFF.

4. Exit the vehicle using both hand holds.

Note: If removing a standard carriage with forks, spread

the forks apart on the carriage shaft. This will help give

the carriage better support to stand alone.

5. Raise the quick attach pin lock lever (Fig. 3-152, 1) and

pull out the lock pin (2) at the bottom of the quick attach.

Figure 3-152 Raise the Quick Attach Pin Lock Lever and

Pull Out the Lock Pin at the Bottom of the Quick Attach

6. Return to the operator’s compartment, fasten the seat

belt and lower the attachment to the ground in a

level position. Tilt the attachment forward; this will

rotate the quick attach link back away from the

attachment.

7. Lower and then retract the boom until the

attachment pivot pins have disconnected from the

attachment.

3.6.2 Connecting to an Attachment

1. Perform this procedure on a level surface only.

Position the vehicle directly behind the attachment to

be mounted.

2. Tilt the quick attach backward.

3. Extend the boom approximately 10 ft (3,05 m), and drive

the vehicle forward until the attachment pivot pins are

below and between the two hooks on the attachment.

4. Raise the boom until the attachment pivot pins have

seated fully in the hooks on the attachment.

5. Tilt the attachment up slightly. The quick attach link

should be tight up against the rear of the attachment,

and the holes in the link and the attachment should

be aligned.

6. Place the travel select lever in the (N) NEUTRAL

position, place the neutral lock lever in the (N)

NEUTRAL LOCK position, engage the parking brake

switch, unbuckle the seat belt and exit the vehicle

using both hand holds.

7. Lift the quick attach lever. Insert the quick attach pin

completely through the attachment and the quick

attach link. Be sure that the quick attach lock lever

has lowered and seated itself into the groove in the

quick attach pin.

8. Return to the cab, fasten the seat belt and resume

operation.

OS03312

WARNING: DO NOT operate the vehicle

unless you are in the operator’s seat with the

seat belt fastened around you. Death or serious

injury could result if the seat belt is not

securely fastened.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 543 544

Comments to this Manuals

No comments

Skytrak 6042 Service Manual User Manual Page 114

Comments to this Manuals

Related products and manuals for Special machinery Skytrak 6042 Service Manual