Skytrak 6042 Service Manual User Manual download pdf (Page 321)

100

101

8.89

Model 6042 Legacy Origin 7/02

Hydraulic System

b. Service Brake Valve Installation

1. Install the service brake valve (Fig. 8-53, 3) with the

four lockwashers (2) and four capscrews (1) to

mount the brake valve to the steering column

support.

Note: ALWAYS replace seals, o-rings, gaskets, etc.,

with new parts to help ensure proper sealing and operation.

Lubricate seals and o-rings with clean hydraulic oil.

2. Use new oiled o-rings as required. Reattach and

secure all valves, hoses, clamps, wiring, etc.

(Fig. 8-52).

3. Check the routing of all hoses, wiring and tubing for

sharp bends or interference with any rotating

members, and install tie wraps and/or protective

conduit as required. Tighten all tube and hose

clamps.

4. Start the engine and run at approximately one-third

to one-half throttle for about one minute without

moving the vehicle or operating any hydraulic

functions.

5. Inspect the service brake valve and connections for

leaks and check the level of the hydraulic fluid in the

reservoir. Shut the engine OFF.

Note: Check for leaks and repair as required before

continuing. Add hydraulic fluid to the reservoir as

needed.

6. Wipe up any hydraulic fluid spillage in, on, near and

around the vehicle, work area and tools.

WARNING: Avoid prolonged engine

operation in closed areas with inadequate

ventilation. Failure to properly ventilate exhaust

fumes can result in death or serious injury.

WARNING: Escaping hydraulic fluid

under pressure can penetrate the skin, causing

death or serious injury.

1 2 ... 316 317 318 319 320 321 322 323 324 325 326 ... 543 544

Comments to this Manuals

No comments

Skytrak 6042 Service Manual User Manual Page 321

Comments to this Manuals

Related products and manuals for Special machinery Skytrak 6042 Service Manual