Skytrak 6042 Service Manual User Manual download pdf (Page 71)

100

101

3.25

Model 6042 Legacy Origin 7/02

Boom

24. Insert the boom sensor (Fig. 3-59, 1) through the

hole in the right side mounting plate (2). Install the

jam nut (3), saved, onto the boom sensor on the

inside of the plate. Adjust the inner and outer jam

nuts on the boom sensor until the gap (4) between

the sensor and the boom is .12" (3 mm). Torque the

inside jam nut to 36 lb-in (4,1 Nm), to hold the boom

sensor in position.

Figure 3-59 Reassemble Boom Sensor

25. Assemble the boom extend tube (Fig. 3-60, 1) to the

inside hole in the mounting plate (2) on the right side

of the boom. Loosely install the nut (3) to the end of

the tube.

26. Assemble the boom retract tube (Fig. 3-60, 4) to the

outside hole in the mounting plate (2) on the right

side of the boom. Loosely install the nut (5) to the

end of the tube.

Figure 3-60 Extend and Retract Tubes

27. Assemble one tube clamp half (Fig. 3-60, 6) to the

weld nut on the right side of the outer boom.

Assemble the other clamp half (6) with the tubes

onto the first clamp half. Place a clamp cover (7)

over the outside clamp half. Secure in place with the

5/16-18 x 2" capscrew (8) and three flat washers (9),

saved. Tighten the capscrew securely.

28. Finish securing both the extend (Fig. 3-60, 1) and

retract (4) tubes to the mounting plate by tightening

the bulkhead nuts (3 and 5) securely.

MA9770

MA9800

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 543 544

Comments to this Manuals

No comments

Skytrak 6042 Service Manual User Manual Page 71

Comments to this Manuals

Related products and manuals for Special machinery Skytrak 6042 Service Manual