Skytrak 6042 Service Manual User Manual download pdf (Page 226)

100

101

Engine: Cummins 4BT3.9

7.32

Model 6042 Legacy Origin 7/02

13. Uncap the lines and install the transmission oil input

(Fig. 7-39, 1) and output (2) hoses to the radiator

fittings (3 and 4).

Figure 7-39 Transmission Oil Hose Connections

14. Secure the throttle cable (Fig. 7-40, 2) to the engine

throttle lever (7), located just above the starter.

15. Install the throttle cable mount clamp (Fig. 7-40, 8)

over the throttle cable (1).

Figure 7-40 Throttle Cable Connection

16. Connect the fuel inlet line (Fig. 7-40, 3) to the fuel lift

pump (4).

17. Connect the fuel return line (Fig. 7-40, 5) to the fuel

injector pump (6).

18. Raise the drive shaft assembly (Fig. 7-41, 1) into

position. The slip-yoke end of the drive shaft mounts

toward the engine. If reinstalling a drive shaft

previously removed, align the flange yokes according to

the alignment marks made during removal.

IMPORTANT: Yokes at both ends of the drive shaft must

be in the same plane to help prevent excessive vibration.

Note: If installing a new drive shaft unit, special attention

need not be applied to installation. New drive shaft units

are balanced at the factory.

19. At the drive shaft (Fig. 7-41, 1), install the four hex-

head capscrews (2), and four lockwashers (3) securing

the flange yoke (4) to the engine. Torque to

105 ±10 lb-ft (142 ±14 Nm).

Figure 7-41 Drive Shaft Installation

20. Install the fuel sender with new gasket (Fig. 7-42, 6)

to the fuel tank.

21. Attach fuel sender harness connectors (Fig. 7-42, 1)

to the sender unit and secure with #10 x 5/8" screws

(5). DO NOT overtighten.

MA9130

MT2530

MA8900

To Transmission

To Engine

1 2 ... 221 222 223 224 225 226 227 228 229 230 231 ... 543 544

Comments to this Manuals

No comments

Skytrak 6042 Service Manual User Manual Page 226

Comments to this Manuals

Related products and manuals for Special machinery Skytrak 6042 Service Manual