Skytrak 6042 Service Manual User Manual download pdf (Page 220)

100

101

Engine: Cummins 4BT3.9

7.26

Model 6042 Legacy Origin 7/02

8. Disconnect the back-up alarm harness connector

(Fig. 7-30, 4) from alarm (5). Disconnect and

remove the back-up alarm.

Figure 7-30 Battery Hold-down and

Back-up Alarm Location

9. Position a suitable container beneath the radiator

(Fig. 7-31, 1). Remove the radiator cap (not shown)

and open the radiator drain petcock (2). Allow the

coolant to drain into the container. Close petcock

after draining.

10. Disconnect the radiator overflow hose (Fig. 7-31, 3)

from the overflow bottle (4). Disconnect and remove

the overflow bottle from vehicle.

Figure 7-31 Radiator Drain Petcock

Note: The exhaust system must be removed from the

vehicle before engine removal. Refer to Section 7.9.1,

“Exhaust System Removal.”

11. Label and disconnect the alternator ground wire

(Fig. 7-32, 1), D+ (2) and B+ (3) harness wire leads.

Figure 7-32 Label and Disconnect the Alternator Wire Leads

Note: Record how the wires are installed to ensure

correct installation later.

12. Remove the two red wires (Fig. 7-33, 1) from the

upper solenoid stud (2).

13. Remove the red, positive (+) battery cable

(Fig. 7-33, 3) from the upper solenoid stud.

14. Label and disconnect the blue/orange wire

(Fig. 7-33, 4) from the starter solenoid housing stud.

15. Remove, the lower 12-point starter bolt (Fig. 7-33, 5)

securing the starter to the flywheel housing. Remove

the negative (-) ground cable (6) from the 12-point

starter mounting bolt. Reinstall the 12-point starter

bolt into the lower starter bolt position.

Figure 7-33 Disconnect Starter Wires

MA7970

OA1310

B+

D+

D-

ORG

BLK

YEL

RED

MA8400

MA8420

1 2 ... 215 216 217 218 219 220 221 222 223 224 225 ... 543 544

Comments to this Manuals

No comments

Skytrak 6042 Service Manual User Manual Page 220

Comments to this Manuals

Related products and manuals for Special machinery Skytrak 6042 Service Manual