Skytrak 6042 Service Manual User Manual download pdf (Page 488)

100

101

Electrical System

9.118

Model 6042 Legacy Origin 7/02

6. Remove the nine lower valve body protective cover

screws (Fig. 9-104, 1), lockwashers (2) protective

cover (3) and gasket (4)

Figure 9-104 Lower Valve Housing Solenoid Replacement

7. Disconnect the internal wire connector (Fig. 9-104, 5)

from the solenoid valve that is being removed. Label

the internal wire connections if removing more than

one solenoid valve.

8. Remove the solenoid capscrew (Fig. 9-104, 6) and

retaining plate (7), securing the solenoid valve (8) to

the transmission.

9. Remove the solenoid valve (Fig. 9-104, 8) and

replace.

f. Transmission Lower Valve Body Solenoid

Installation

Note: When installing the solenoid valve into the valve

body, position the solenoid valve wires so they do not

interfere with the protective cover plate.

1. Install the solenoid valve (Fig. 9-104, 8) and

retaining plate (7). Connect the internal wire

connector (5) to the solenoid. Insure that the claw

side (7) of the retaining plate is facing down toward

the valve body surface.

2. Install the solenoid capscrew (Fig. 9-104, 6) and

torque to 53 lb/in (6 Nm).

3. Install the protective cover gasket (Fig. 9-104, 4)

onto the valve body. Position the protective cover (3)

over the gasket. Install lockwashers (2) and

capscrews (1), and tighten until the cover plate is

compressed and it sits flush over the gasket. Torque

to 84 lb/in (9,5 Nm).

4. Install the upper transmission valve body gasket and

upper valve body assembly to transmission.

5. Install the lockwashers and capscrews, and torque

screws to 84 lb/in (9,5 Nm).

MT2480

1 2 ... 483 484 485 486 487 488 489 490 491 492 493 ... 543 544

Comments to this Manuals

No comments

Skytrak 6042 Service Manual User Manual Page 488

Comments to this Manuals

Related products and manuals for Special machinery Skytrak 6042 Service Manual